Our billet Eversen D44 caps seal the ends of your hubs when using a Dana 44 as a 2wd setup. The simplicity of the cap design allows you to eliminate any internal 4x4 components previously retained to hold the cap on. No small screws or snap rings to fumble around with. These caps utilize ball detents that firmly snap into the factory retaining ring groove, and seal with high quality serviceable o-rings. Engineered to be secure yet able to be worked off by hand, eliminating the need for tools to access your bearing nuts. However there is a notch located above each detent if you prefer to use a tool to pry them free.
Precision machined in the USA from domestic 6061 material.
Sold as a pair.
Available in raw aluminum or dark hard anodize finishes. Tool patterns may vary.
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device